AC Drive China Forum
Forum » General Discussion » New or used motor request
Topics: New or used motor request on General Discussion
Start by
Mark St Martin
12-31-2013 10:39 PM

New or used motor request

I'm looking for a 200-Hp 3600-RPM 575-volt motor in a 505U frame TEFC
Are there any out there?
Thanks! Mark
01-01-2014 12:52 AM
Top #2
Thomas Yarwood
01-01-2014 12:52 AM
i have worked in the Electric motor repair trade for well over 35 years , the company i presently work for is world wide ERIKS EMS we repair and sell motors of all types and sizes , 1 phase to 3 phase also DC verying voltages ERIKS also sell replacement sealing devices, hydrolic and numatic devices for what ever poropuse or requirement also gearboxes and drives mechical or electrical , i am sure if you give any of our branches a telephone call they can surley help you sort out your requirements !!.
01-01-2014 03:31 AM
Top #3
Chris Heron
01-01-2014 03:31 AM
Asking for the rating in a 505U (or 505UZ) frame size is severely limiting the availability of motor manufacturers. For this rating, most manufacturers are in a 445 frame size ... unless there's something special about the application that you have not conveyed.

And with the smaller frame, the chances are pretty good that an intermediate soleplate can be made to adjust for the mechanical mounting differences like hold-down bolt location and shaft centerline height.

And yes - the 445 frames are available on the used market as well!
Reply to Thread